See our online support regarding Failed Inspections for guidance on correcting these. If a trailer is not created in the system but is used when doing inspections, this can cause inspections to fail. A GPS ID is not required for trailers unless one has been installed. Required: Add the trailer to Ground Traffic Control (GTC) like other assets but with the TRAILER asset type. These tags include both a 9-digit asset number and a zone number 01-03. They ship in sets of two (2) or three (3) tags with the name “Ext. Trailer/Dolly Tags are considered “Extended Asset” tags and may be black or marigold colored. Perform an electronic inspection to ensure correct tag placement.Depending on the configuration, not all zone tags may be used. Install the zone tags in the proper areas for the corresponding vehicle inspection type.See the Zonar Configuration Document for proper zone tag placement.Remove the adhesive from the asset tag and record the Tag ID number on an asset sheet:.Vehicle TagsĬlean the surface area of the asset with isopropyl alcohol or brake cleaner before installing tags. Skip this section if electronic inspections (EVIR) will not be used for the vehicle receiving installation. The following is an example of how to record this information on an Asset sheet: Record the asset (vehicle name) and the GPS being installed-this is important in order for the Zonar data to attach to the correct asset.Find the GPSID (S/N) number on the back of the unit.The installation technician must record which GPS unit is being installed in each vehicle before any Zonar equipment is installed.
0 Comments
Leave a Reply. |